Conversation

wizardry variants lori

I see 3D prints like this a lot (in general, but especially for Pringles because I search Pringles a lot to find prints for repurposing cans for other stuff) and I just think like...there's no universe where I'm going to take all the Pringles out and put them in this tray and put it back in every time I eat them

3
0
0

I mean yes I see the problem this is trying to solve but it creates more work than it's worth

0
0
0
@kib
At that point just cut the can in half!
0
0
0

@kib

Is it "open" in the back? If it is, it looks like you could slide it in upside down at the top of the Pringles can while the Pringles are in there, and then rotate 180 degrees.

1
0
0

@nyquildotorg I guess you'd need to use it differently than the picture shows and also not jostle it too bad lol

0
0
0